HEINZMANN Company Group

HEINZMANN Electric Drives
Robust electric motors

REGULATEURS EUROPA
Control & Monitoring

HEINZMANN China
Control & Actuation

HEINZMANN Automation
Marine Automation

HEINZMANN UK
Gas & Water Turbine Control

HEINZMANN Australia
Steam Turbine Control

CPK Automotive
Emission Control

Giro Engineering
Diesel Engine Components

Technologies empowering efficiency

 

REGULATEURS EUROPA provides electrically driven governor test stands for permanent installation. The purpose of the rig is to assist in adjusting, servicing and testing the performance of hydraulic speed governors and hydraulic actuators. Our test stands have been designed to simulate diesel engine operating conditions; the governor and test stand forming a closed loop system.  For the setting–up and testing of hydraulic actuators the test stand can also operate in open loop mode. In that instance the drive speed is set at, and controlled from, the stand itself.

  • Test Stand AK8
  • Actuator Charger / Tester
  • Actuator Calibration Unit

Test Stand AK8

For testing of governors and actuators of all major brands. The basis of the test stand is a sophisticated PLC. The PLC controls a frequency converter which in turn drives a 5.5 kW electric motor. The governor or actuator is direct driven by the electric motor. When in closed loop mode, the test stand simulates a diesel engine. This means that the "load" on the engine is simulated by the test stand. If the set speed of the governor is altered the governor output will change momentary to increase or decrease the amount of "fuel" applied. This will cause the drive speed to change accordingly. Also if the simulated load on the test stand is changed the output position of the governor will change to maintain the set speed.

Main features:

  • All-electric. 5.5 kW drive
  • Includes oil supply to fill the governor under test
  • Governor oil may be circulated and pre-heated
  • Operated from a 15" colour touch screen HMI
  • Includes 4 ... 20 mA speed setting driver
  • Operates in open and closed loop mode

 

More information

Data Sheet

Actuator Charger / Tester

For calibration of all RE actuators. The magnets in all RE actuators are accurately calibrated at the factory guaranteeing the actuator performs in the precise manner the design intended. At overhaul of the actuator and/or strip down of the actuator assembly it is essential to re-calibrate the magnet to maintain the accurate operation of the unit. The RE actuator charger/tester is designed specifically to do this task and is available in either 110 VAC or 230 VAC 50/60 Hz power supply format. The functionality of this independent unit is built into the AK8 test stand above.

Main features:

  • Includes oil supply to fill the governor under test
  • Governor oil may be circulated and pre-heated
  • Operated from a 15" colour touch screen HMI
  • Includes 4-20 mA speed setting driver
  • Operates in open and closed loop mode

 

More information

Manual

Actuator Calibration Unit

The actuator calibration unit ACU is a tool for maintenance and repair of HEINZMANN actuators. It is designed to perform a general working test of actuators and to calibrate actuators analogue feedback.

Main features:

  • Analogue feedback calibration
  • General working test
  • Cable harness included
  • Applicable for:
    StG 6, StG 10,
    StG 16 to StG 40,
    StG 64 and StG 90 with or without brake,
    StG 180 with or without brake
    StG 2010, StG 2040 and StG 2080 with standard Cannon plugs

 

More information

Manual